Portable analyzer for VOC (Volatile Organic Compounds) analysis

The Polaris device, a portable analyzer for VOC (Volatile Organic Compounds) analysis, is a compact and lightweight instrument, despite being composed of two large half-shells. The customer relied on us to obtain the best solution for the creation of the production mold. Given the large size of the shells, the investment for two traditional molds would certainly have been expensive and there was the risk of not finding adequate compensation in the sales volumes expected for the first years of the product launch.

By analyzing the files, the dimensions of the shells, and optimizing production costs as best as possible, there were two alternatives: designing two prototype molds or a mold with interchangeable matrices.

Share

Portfolio Description

At Coesum we have always dealt with rapid prototyping and design and production of injection molds for plastic. Usually the development cycle of a product goes through design, engineering, prototyping and mass production. If we are talking about a complex product with multiple assembly elements, each of them will have its own “matrix” in the production mold. However, there are some borderline cases, in which some conditions or factors external to pure design influence the choices to the point of determining them.

This is the case of the Polaris device, a portable analyzer for VOC (Volatile Organic Compounds) analysis. Designed by Pollution s.r.l., it is compact and lightweight overall, despite being composed of two large half-shells, 350x360x111mm each. Pollution s.r.l. relied on us to obtain the best solution for the creation of the mold. Given the large size of the shells, the investment for two traditional molds would certainly have been expensive and there was the risk of not finding adequate compensation in the sales volumes expected for the first years of the product launch.

When we started following the project, the customer had already defined a design draft and created productions through rapid prototyping processes.

After the first tests, the customer’s need was to start a definitive production to be used for marketing the product.

By analyzing the files, the dimensions of the shells, and optimizing production costs as best as possible, there could be two alternatives:

  • Prototype mold is a suitable solution for the production of small batches of plastic material, even co-molded; it is convenient when it is not necessary to purchase the production equipment, and it is necessary to have low-volume production, with definitive material in 5/6 weeks. It is temporary equipment that remains available for molding for 12 months; after this period it is necessary to produce the definitive mold or a new prototype mold.
  • Mold with interchangeable matrices is a solution in which, on a single mold, it is possible to insert multiple figures and therefore produce different geometries. In this specific case, since the two half-shells are the same size, it could be a viable solution.

Pollution has chosen the second solution to have the guarantee of continuous production over time on short runs.

The first step, after choosing the production process, was to engineer the files for the production process with thickness optimization, insertion of draft angles to facilitate extraction, insertion of internal ribs, elimination of undercuts, standardizing the positioning of the screws for post-production hot insertion.

This first phase starts with the feasibility study up to the final preparation of the 3D CAD. Once the geometry was defined, we started the design of the molds. In this phase, filling simulations were performed in the software and all the specifications regarding the finishing of the molded piece, the injection point, the level of embossing were shared with the customer.

At the end of the mold production we performed a molding test, a fundamental step for dimensional control and mold acceptance.

The injection molding production is performed in PA6+15%GF – Color RAL 5019.

An interesting and challenging project also considering the large dimensions of the shells.

All the co-design activities and the excellent collaboration with the customer have contributed to optimizing the costs of internal processing and quality control, reducing non-conformities on the product by 98% compared to previous production technologies.

Share

Pin It on Pinterest